Custom Dynamics ProBeam Add-On Mini Taillight Red Lens Harley Touring 10-13

Simple plug and play solution to add a third brake light to the rear fender! ProBEAM® LED Taillights have been engineered from the ground up using the highest quality automotive LEDs and modern light pipe design! Custom Dynamics® premium line of aftermarket LED taillights now provides increased side visibility to maximize safety through modern technology for Harley-Davidson® motorcycles. Three running LED light pipes illuminate across the taillight as a running light with 10 full intensity brake LEDs to provide maximum safety and visibility.

Two mounting configurations available to install in addition to the OEM rear turn signal bar or to use with Custom Dynamics® Rear Turn Signal Eliminator License Plate Mount (sold separately). If installing with OEM rear turn signal bar, taillight mounts with attached mounting bracket utilizing factory turn signal bar bolts. Turn Signal Eliminator configuration mounts to the fender with doublesided tape, wiring is concealed behind the Turn Signal Eliminator License Plate Mount (sold separately). The Low-Profile taillight design protrudes only two inches from the fender for a sleek custom look. Available with a Red or Smoked lens. Lifetime warranty against LED failure. 

Plug and play installation for 2010-2013 Street Glide (FLHX) and Road Glide Custom (FLTRX).

Use in conjunction with Custom Dynamics® Magic Strobes™ Brake Light Flasher module to add full contrast brake flash or strobe patterns for even more visibility!

• Simple solution to add a third brake light to the rear fender
• The Low-Profile taillight design protrudes only two inches from the fender for a sleek custom look
• Modern LED light pipe design with three running light pipes
• Three running LED light pipes illuminate across the taillight as a running light with 10 full intensity brake LEDs
• Completely sealed unit mounts with double-sided tape to the rear fender and wires route behind the Turn Signal Eliminator bracket
• Plug and play, no drilling required

NOTE: Does not fit CVO™ models